0~12V 0~800A IGBT-based Rectifier for Copper Foil Electrolytic

Product Description:

Specifications:

Input parameters: Three phase AC380V±10%, 50HZ

Output parameters: DC 0~12V 0~800A

Output mode: Common DC output

Cooling method: Air cooling

Power supply type: IGBT-based High-frequency Power Supply

Application Industry: Electrolytic copper foil industr

Product size: 50*40*25cm

Net weight: 28kg

Send Email to Us

Specification
Faucet Type	Bathroom Sink Faucets,
Installation Type	Centerset,
Installation Holes	One Hole,
Number of Handles	Single Handle,
Finish	Ti-PVD,
Style	Country,
Flow Rate	1.5 GPM (5.7 L/min) max,
Valve Type	Ceramic Valve,
Cold and Hot Switch	Yes,
Dimensions
Overall Height	240 mm ( 9.5 " ),
Spout Height	155 mm ( 6.1 " ),
Spout Length	160 mm ( 6.3 " ),
Faucet center	Single Hole,
Material
Faucet Body Material	Brass,
Faucet Spout Material	Brass,
Faucet Handle Material	Brass,
Accessories Information
Valve included	Yes,
Drain included	No,
Weights
Net Weight (kg)	0.99,
Shipping Weight (kg)	1.17,

feature

Input Parameters

AC Input 480v±10% 3 Phase
Output Parameters

DC 0~50V 0~5000A continuously adjustable
Output Power

250KW
Cooling Method

forced air cooling / water cooling
PLC Analog

0-10V/ 4-20mA/ 0-5V
Interface

RS485/ RS232
Control Mode

remote control design
Screen Display

digital display
Multiple Protections

lack phase over-heating over-voltage over-current short circuit
Control Way

PLC/ Microcontroller

Model & Data

Model number	Output ripple	Current display precision	Volt display precision	CC/CV Precision	Ramp-up and ramp-down	Over-shoot
GKD12-800CVC	VPP≤0.5%	≤10mA	≤10mV	≤10mA/10mV	0~99S	No

Product Applications

Electrolytic copper foil refers to copper material as the main raw material, using electrolytic copper foil production. Dissolve copper material by copper sulfate solution, then in electrolytic equipment, copper sulfate solution by direct current electrodeposition and made the original foil, again carries on the coarsening, curing, heat resistant, corrosion resistant layer, prevent oxidation layer surface treatment, such as lithium electricity copper foil axial-flow compressor.in order main surface oxidation treatment, finally made after cutting, testing the finished product.

During electrolysis, cations in the electrolyte migrate to the cathode and electrons are reduced at the anode. The anion runs to the anode and loses electrons to be oxidized. Two electrodes were connected in copper sulfate solution and direct current was applied. At this point, copper and hydrogen will be found to precipitate from the plate connected to the cathode of the power supply. If it is a copper anode, copper dissolution and oxygen precipitation occur simultaneously.

The module of the synchronous rectifier high-frequency switching power supply is installed in the parallel cabinet, and is connected with the cathode and anode bus of the foil generator through the output of the bus. Clean appearance, compact structure. High power conversion efficiency, reduce customer use cost. Power supply adopts N + 1 backup mode, which can realize thermal maintenance of the whole machine and ensure continuous production by customers.